Gigaset Euroset 5030 Mode D'emploi page 10

Using Calling Line Identification
Under the following conditions, the phone numbers of
incoming calls are
(a) shown on the display (up to the first 32 digits) and
(b) automatically saved in a calls list:
◆ Both your network provider and the caller's network
provider must offer Calling Line Identification.
◆
Both you and the caller must have requested this service
(if necessary) from your respective network providers.
If these conditions are met, but a caller has suppressed
Calling Line Identification before making the call, you will
see "Private" or "Out of Area" on the display instead of the
(flashing) phone number.
Up to 16 digits can be shown on the display. Longer
telephone numbers will be shortened from the end of the
number.
If the phone number is stored in the directory, the assigned
name will be displayed instead of the phone number.
Picking up a waiting call
If you receive a call during another call, you will hear the
call waiting tone in the handset. If the phone number is
transmitted, it (or the corresponding directory entry,
if available) will appear on the display.
You can switch back and forth between the current call and
the waiting call using the key sequence
ing on your network provider this key sequence may vary. In
doubt, contact your network provider
Calls list
The calls list includes up to 50 entries. If a subscriber calls
›
several times, appears in the display.
Sequence of list entries: The most recent call is displayed
in the first position (position number "01"). Older entries are
moved downwards with each new incoming phone number
until they are deleted from the list.
In the calls list, you can
◆
scroll through the phone numbers displayed
◆
delete entries
◆
Save phone numbers from the calls list to a repertory key
or in the Directory (see page 4)
◆
dial a displayed phone number directly.
Viewing caller histories and dialling phone numbers
If there are entries in the calls list that have you have not
|
yet seen, flashes in the display. The number of list
entries which have not been viewed yet is displayed.
A
Press the Down key.
8
GB
A
B
AB
Deleting entries in the calls list
A
B
AB
B
AB
Activating/deactivating display of the prefix
You can set the telephone so that the prefix is not displayed
for incoming calls. This can be useful, for example, if you
cannot see the last digits of a long phone number on the
>2 . Depend- display.
You can deactivate the display for one area code (up to 6
digits).
F
o
>
B
Activating/deactivating the display of incoming
phone numbers during a call
The CLIP display of incoming phone numbers during a call
can be activated or deactivated.
F
AB
Scroll through the calls list:
C
... Press the Down/Up key.
Dial the phone number:
At the selected entry, press the OK key.
In the menu, select Call Back. Press the OK key.
After 2 seconds the number is dialled.
Lift the handset if you want to talk via the
handset.
Delete individual entries
C
... Scroll through the calls list to the desired entry.
Press the OK key.
In the menu, select Delete. Press the OK key.
Delete all entries at the same time
In the calls list, press the OK key.
In the menu, select Delete All.
Press the OK key.
The calls list is closed.
¢ ¢
SMS/CLIP Setup Area Code
Entering the prefix:
Enter a one to six-digit prefix (without the
enquiry call key).
Deleting the prefix:
... > You can delete the emergency number one
character at a time using the R-key
Press the OK key.
¢ ¢
SMS/CLIP Setup CLI on CW
In the menu, select Disable or Enable.
Press the OK key.