Assembly Instruction - POWER SMITH PVLR8000A Mode D'emploi

ASSEMBLY INSTRUCTION

SETTING UP AND BREAKING DOWN THE LIGHT (FIG 2)
Your work light is fully assembled and ready to use out of the box.
To Set Up the Light:
From folded position A to working position D.
1. Unwrap the storage strap (18).
2. Release the leg locking clip (10). See position A.
3. Expand the tripod legs (11) and then lock the leg locking clip. See
position B.
4. Place the light head locking button (2) in unlock position, then flip
the light heads (1) up. See position C.
5. Release the tripod locking clips (7), raise the tripod (8) and lock
the tripod locking clips. See position D.
6. Adjust the light heads (1) to a desired position.
To Break Down the Light:
1. Release the tripod locking clips (7), lower tripod all the way down
and lock the tripod locking clips.
2. Fold the light heads (1) down in a tube shape.
3. Release the leg locking clip (10).
4. Raise the leg connector (9) until the light heads nest inside.
5. Lock the leg locking clip.
6. Wrap the legs with the storage strap.
You may also refer to the "QUICK START GUIDE" sheet that is included with the product.
INSTALLING AND REMOVING THE BATTERY PACK (FIG 3)
A 12V lithium-ion battery pack (Model# PVLAB121) is pre-installed under the tripod pole.
NOTE:
Remove the insulation tape on the battery terminals before
using.
To Remove the Battery Pack from the Light:
battery locking pin, and then remove the battery as shown in FIG 3.
To Install the Battery Pack:
with the "battery symbol", slide the battery pack into the battery
holder all the way until it locks in place with a click, as shown in FIG
3. Lightly pull on the battery to ensure it is locked into place and will
not accidentally fall out.
CHARGING THE BATTERY PACK (FIG 4)
1. Plug the battery charger into a power source.
2. Unplug the rubber insert to expose the charging port.
3. Connect the battery charger to the charging port.
4. The battery power indicator will light and show the charging status:
Red light flashing: Low power and charging.
Yellow light flashing: Over 50% power and charging.
Green light flashing: Over 80% power and charging.
Solid green light: Fully charged.
You may charge the battery pack either installed or removed from the
light. If charging while installed, the light works with maximum brightness
at 4000 lumens.
English
From postion D back to position A.
Slide down the
Facing the side of the tripod base
OPERATION
5
A
C
FIG 2
BATTERY
SYMBOL
LOCKING PIN
FIG 3
BATTERY
ChARGER
BATTERY PACK
RuBBER
INSERT
ChARGING
PORT
BATTERY POwER
INDICATOR
B
D
BATTERY PACK
hOLDER
BATTERY PACK
FIG 4