Assembly Instruction - POWER SMITH PWL2150TS Manuel D'utilisation

ASSEMBLY INSTRUCTION

SET UP AND ADJUST THE TRIPOD (FIG 2)
1. Loosen the tripod locking knob (F).
2. Push down the leg connector (A) until the legs (B) are fully extended
and firmly tighten the locking knob (F).
3. Adjust the height of the tripod by loosening the twist collars (C1
& C2) and raising the center poles (D1 & D2) of the tripod. Firmly
tighten the twist collars when the tripod reaches the desired height.
NOTE
: The maximum height of this tripod is 65".
4. Loosen the twist collar (C3) and adjust the extendable leg (B2) to
level the tripod on uneven surfaces. Tighten the collar (C3) after
leveling.
ATTACH THE CARRYING HANDLE TO
THE STAND (FIG 2)
1. Place the carrying handle (1) vertically on the stand (7).
2. Use two hex screws (10), flat washers and spring washers to secure
the carrying handle on the stand as shown in FIG 2.
ATTACH THE WORK LIGHT HEADS TO
THE STAND (FIG 2, 3)
1. Place the stand (7) on a flat surface.
2. Use the locking knobs (8), flat washers and spring washers to
secure both work light heads on the sides of the stand as shown in
FIG 2.
3. Use a twist knob (12) to attach the power cable connector (13) to
the carrying handle as shown in FIG 3.
ATTACH THE WORK LIGHT ASSEMBLY
TO THE TRIPOD (FIG 2, 4)
1. Place the work light assembly on the top of the tripod. Insert bottom
ends of the two Hex screws (10) into two holes on the supporting
bracket (E).
2. Use the bracket locking system (E1, E2 and E3) to secure the work
light assembly to the tripod as shown in FIG 4.
English
FIG 2
12
FIG 3
FIG 4
4
1
2
8
E1
7
E2 E3
D2
C2
A
B
F
1
13
E1
2
8
10
E
D1
C1
B
C3
B2
E2
E3