Accessories - POWER SMITH PVLR8000A Mode D'emploi

ON-BOARD SWITCH
Your light has a red on-board switch (5-FIG 1). See Figure 1 for its location. This switch turns the light On and Off and
controls the light mode. The light mode cycles in the following sequence with each press on the switch:
High - Medium - Low - Night Light - OFF
The switch has a delayed "OFF" function. If a light mode stays on for more than 15 seconds, the next press of the
switch will turn off the light.
REMOTE CONTROL (FIG 5)
Your light includes a remote control PARC23 (6-FIG 1). It docks in the middle of the tripod
pole.
There are two buttons on the remote. The top one (A) is to turn the light On or Off. The
bottom one (B) is to select the light mode among High, Medium, Low, Night Light and
Flashing Alert Light.
Slide the remote up to take it off the holder. Always keep it in the holder when not in use.
The maximum control range is approximately 60 feet from the light.
The remote is powered by a 3V Lithium-Ion button battery CR2032L. Remove the four
screws on the back cover to replace the battery.
The included remote control has been paired with your LED Work Light at the factory. If you are using a replacement
remote control, pairing the remote with the light is needed. Remove the battery pack from the light and reinstall it.
Press and hold the On/Off button (A) on the remote for at least 7 seconds until the light turns on. This completes the
pairing process and the remote is ready to use.
NOTE:
Your light will turn to a sleep mode 24 hours after being turned off to save battery power. Press and hold the
On/Off button (A) on the remote control for 2 seconds to awaken the light.
WARNING:
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
ADJUSTING THE LIGHT HEADS
Your light has four adjustable light heads. They can be configured in dozens of ways
to get light where it is needed.
Flipping the Light Heads:
light heads on each side up or down to the desired position. Lock the light heads by
placing the lock button in Lock
Rotating the Light Heads:
center axis. See Fig 8.
CAuTION:
Do not force the light head. If it stops rotating in one direction, rotate
in the other direction to reach the desired position.

ACCESSORIES

Foot Spikes (FIG 9)
Three foot spikes are included for extra hold in tough conditions. Hammer the foot
spike into soft ground though two holes on the foot to give the light extra stability.
The foot spike can be stored in the feet as shown in FIG 9.
Shoulder Strap
An adjustable shoulder strap is Included for easy transport.
English
This device complies with part 15 of the FCC Rules. Operation is subject to the
Place the lock button (2) in Unlock
position. See Fig 6 & 7.
The light heads are able to rotate 330° around their
6
FIG 6
position. Flip the
FIG 7
FIG 8
FIG 9
A
B
FIG 5
2