Martin Logan ElectroMotion FX2 Mode D'emploi page 6

Fig. 6A
Fig. 6B
6
Required hardware (not supplied):
• (2) 1.5-inch Phillips sheet metal screws
• (2) Sheet rock anchors
Required tools (not supplied):
• Ruler
• Level
• Electric drill and 1/4" and 1/8" drill bits
• Phillips screwdriver
1 Screw the shoulder bolt into the back and
install the rubber bumpers in the location shown
(fig. 4).
2 Locate mounting location using a level and the
installation template (fig. 5A–5B).
3 Mark the pilot hole locations.
4 Drill the pilot holes using a 1/8-inch drill bit. If
a pilot hole DOES NOT hit a stud, widen that
pilot hole using a 1/4-inch drill bit and install
a wall anchor at that location (fig. 6A & 6B).
5 Using the 1.5-inch Phillips screws, mount the
wall brackets as shown (fig. 6A & 6B).
6 Hang the speaker, guiding the wall mount bolt
into the wall bracket's keyhole.