Manual Operation; Operating Modes; Software Functions - Kessel SonicControl Instructions D'utilisation

6 Operation
6.1

Operating modes

As soon as it is initialised, this KESSEL control unit has the following operating states.
Automatic operation (normal operation)

Manual operation

Battery operation
6.2

Software functions

Automatic operation
The control unit enters the following values daily in the
the grease layer thickness
The control unit enters the following values daily in the
averaged temperature of the respective days
highest and lowest temperature measured on the respective day
temperature at the time of the layer thickness measurement
The operation is documented in the log book (
Maintenance
Error (battery error, etc.)
Adjustments of the settings
6.3 Manual operation
A measurement of the grease layer thickness can be triggered manually in the control unit.
Navigate in the menu via
|Layer thickness|
Select menu item
Wait for a short time until the measurement result is displayed, then confirm or discard.
6.4 Acknowledge alarm
The control unit displays (alarm) messages as follows:
the alarm LED flashes red,
an error message appears in the display,
an acoustic signal sounds.
Press the Alarm button for 3 seconds to acknowledge.
If the cause of the error has been corrected, the acoustic
signal falls silent and the LED stops flashing.
Pressing the Alarm button briefly switches off the acoustic
alarm; however, the error message remains in the display
and flashes.
016-283
The control unit monitors and controls the connected electronic components
without limitation.
The control unit sends an additional scan pulse and determines the current
layer thickness, and then notes it in the log book.
The control unit switches off its sensors and sends alarm messages.
|1.7 Measured data|
|1.5.2 Separator temperature|
|1.2 Log book|menu item)
|Maintenance| |2.1 Manual operation|
to the
and confirm with OK.
Installation and operating instructions
menu item:
menu item:
:
area.
25 / 96