Troubleshooting; Spare Parts And Accessories; Warranty - Wolf Garten A 400 E Mode D'emploi

English

Troubleshooting

Problem
Uneven running,
lawnmower vibrates
excessively.
Motor is not running. The fuse on the mains connection
Poor mowing/
catching capacity.
If in doubt, always visit a service centre.
Attention! Before checking or working on the cutter bar, always switch the lawnmower off and pull
out the mains plug.

Spare parts and accessories

Order no.
196-122-650
196-123-650
196-124-650

Warranty

The warranty regulations issued by our company or the importer are valid in all countries.
Your lawnmower will be repaired free of charge under the warranty, provided the cause was a material
or manufacturing fault. In the event of a claim under the warranty, please contact your dealer or nearest
branch office.
22
Possible cause
The cutter bar is damaged.
The cutter bar has become detached.
has tripped/is defective.
Procedure in the event of a damaged
cable:
Attention!
Electric shock due to damaged
cable!
The fuse will not always trip if the cable
is severed or damaged.
Do not touch the cable until the mains
plug has been pulled out of the socket.
Have damaged cables repaired
by an electrician or the service centre.
It is forbidden to patch the cable with
insulating tape.
The cutter bar is blunt.
The grass catcher bag is blocked.
The cutting height has not been adjusted. Follow the instructions in the chapter
Article designation
WBL3401
WBL3701
WBL4001
Remedial action
Contact a service centre.
Follow the instructions in the chapter
"Changing the cutter bar".
Have it repaired by an electrician.
Contact a service centre.
Contact a service centre.
Follow the instructions in the chapter
"Emptying the grass catcher bag".
"Adjusting the cutting height".
Article description
Cutter bar A340 (34 cm cutting width)
Cutter bar A370 (37 cm cutting width)
Cutter bar A400 (40 cm cutting width)
Operating instructions lawnmower
Troubleshooting