Mendip Stoves Christon 550 Guide D'utilisation Et Mode D'emploi page 9

HOW TO OPERATE YOUR STOVE
Suitable fuels
Your stove is tested to burn wood. Wood briquettes can also be burnt but special account should be taken of fuel weight.
For a full list of suitable fuels, check with the official solid fuels approvals body, HETAS or Solid Fuel Association. Do not
overload stove as this can cause excessive heat and damage the stove (see table on page 5).
ALWAYS KEEP FUEL LOAD BELOW TERTIARY PORTS AT REAR OF STOVE. Only use fuels approved for use on heating stoves.
Do not burn liquid fuels, drift wood, finished wood, sawn wood, pallet wood, chipboard/plywood ,varnished wood or
plastic coated wood, wood treated with preservatives, or any house hold waste.
DO NOT BURN HOUSE COAL. DO NOT BURN HOUSEHOLD WASTE.
MENDIP STOVES RECOMMEND THE USE OF A FLUE THERMOSTAT TO CHECK YOUR STOVE IS NOT
OVERHEATING. PLACE FLUE THERMOSTAT DIRECTLY ABOVE COLLAR OF STOVE AND REFER TO
TEMPERATURE GAUGE ON PAGE 4.
LIGHTING YOUR STOVE FOR THE FIRST TIME
Before lighting your stove for first time make sure you have read this manual fully and acquainted yourself with the
controls of this appliance. (see page 9)
The heat-resistant paint on your stove will cure and harden the first time you light your appliance.
The curing process produces a good deal of smoke and odour, it is therefore important that the first time you light your
stove the room should be well ventilated.
During the process it is important to open and close the stove door periodically (every 30mins) during the first couple of
firings therefore preventing the door seal cord around the door from sticking and coming away from the door. Once the
heat-resistant paint has hardened the smell will disappear.
Your stove is NOT designed to be used with the door open, the stove door must be kept closed except when lighting the
stove, adding firewood or removing ash in order to prevent flue gases from escaping.
Use of Fire lighters
Quality Firelighters should be used when lighting your stove. (Never use mentholated spirit, petrol or other flammable
liquids). Lighting your stove with firelighters will be more reliable and easier than using paper. Lighting your fire with
paper results in excess smoke, more ash and possible blackening of glass.
OPERATING THE AIR CONTROL LEVER
The Universal Air Control Lever (UAC) determines how much air is admitted into your stove, as well as where it is
directed into the combustion chamber:
Sliding the control lever in and out respectively reduces and increases the total amount of air available to the stove.
Minimum Air Input
Moving the control lever from left to right determines where the external air is directed into the combustion chamber:
By moving the control lever to the left increases the primary air mix, moving the UAC to the right increases the
secondary air.
Maximum Primary Air Mix
Whatever position the control is set at, the lever can have either minimum combustion air or maximum combustion air.
DO NOT EXCEED SPECIFIED FUEL WEIGHTS.
THIS APPLIANCE IS NOT AN INCINERATOR.
Exclusively Secondary Air
Maximum Air Input