ARIETE SMART 2735 Mode D'emploi page 11

VACUUM CLEANER ASSEMBLY
Insert the hose into the suction opening, pressing it down until it slots into place. To remove the hose,
press the two release buttons together and pull it out (FIG. 2).
CAUTION: Before fitting or removing attachments, always be sure to unplug the appliance from the
mains power.
ATTACHMENTS
Telescopic tube (M)
Insert the extension tube onto the handgrip and then fit the required attachment, such as the crevice
nozzle or the small cleaner. Once the attachment has been inserted, it is possible to extend the
telescopic tube to the required length using the lever (FIG. 3). Release the lever to secure the tube
at the required length.
Floor brush (Q)
- Suitable to clean large areas as well as those corners that are hard to reach
- We advise against using the brush on carpets or hard floors. To retract the brush, press the power
lever marked with the carpet symbol
- For better cleaning and preservation of smooth flooring, such as PVC, parquet or tiles, it is advis-
able to use the brush. To extract the brush, press the power lever marked with the smooth floor
symbol
Narrow suction nozzle with brush (L)
This suction device is ideal for cleaning between the folds on fabrics, joints, corners or niches that
are impossible to reach using the floor cleaning device. This attachment can also be fitted directly to
the handle (O).
USINg THE APPLIANCE
CAUTION: Before using the vacuum cleaner, remove all large or sharp objects from the floor to avoid
any possible damage to the cleaner itself.
First of all, before using this appliance, unwind the power cord fully and plug it in. To switch on, press
the On/Off switch on the vacuum cleaner (FIG. 4).
IMPORTANT: Sometimes the appliance will make a whistling sound when switched on; this is not a
defect and will gradually go away with use.
Suction power adjustment
It is possible to regulate the suction power as required, using the relevant dial (E). We recommend
using a minimum power for delicate materials. Select medium suction power for mattresses, uphol-
stered furniture and carpets. Select maximum suction power for tiled, wood or other resistant floors.
Suction control
The secondary air valve (P) is located on the handgrip and it is used to adjust suction power
(FIG. 5).
- The larger the valve opening, the lower the suction power and vice versa.
- To open the valve, push the lever upwards and to close it, push the lever downwards.
.
.
- 9 -
EN