Take Pictures - LAGOS paintTROTTER REFINISH EVO Manuel De Montage Et D'utilisation

EN
KIT CONTENT
PACKAGING
UNPACKAGING
ASSEMBLY
SAFETY INSTRUCTIONS
INSTRUCTIONS FOR USE
DESCRIPTION OF THE ASPIRATION
REPLACEMENT OF THE EXTRACTION FILTERS
MOTOR TURNING CHECK
COMMISIONING INSTRUCTIONS
WARRANTY
TECHNICAL CHARACTERISTICS
CONTROL PANEL
SPARE PART LIST
CERTIFICATIONS paintTROTTER EVO
COMPLIANCE WITH REGULATIONS
KIT CONTENT
paintTROTTER
A box containing:
• 1 box of 100 piercing screws of 4,8 x 16 mm
• 1 plastic film dispenser
• 1 plastic film distributor
• 1 USB including mounting and usage instructions
- PALLET INSPECTION
It is very important to check the pallet and take pictu-
res if is damaged upon arrival (a damaged part of the pa-
llet may carry imperfections of the product underneath).
With this action we can then claim the damage to the carrier.
Write on the delivery note the following sen-tence
(with copy to your local distributor) :
In compliance with reservations until
further examination

Take pictures

PACKAGING
PaintTROTTER is packed using a wooden boxpallet to prevent
possible damage caused during transport.
......................... 15
......................... 15
......................... 15
......................... 16
......................... 18
......................... 19
......................... 19
......................... 20
......................... 21
......................... 22
......................... 25
......................... 25
......................... 25
......................... 25
......................... 26
......................... 27
The pallet design allows the movement through cargo transport
vehicles. Check the signs on the pallet to locate the fixation
points.
Remove the box boards and plastics to start working with the
machine.
UNPACKING
1. Place the pallet in a firm and flat floor. Make use of a free
surface for mounting the paintTROTTER.
2. Separating the structure with the light.
3. Remove from the pallet the input filter structure. Slide it up
until the front wheels rest on the ground. Then slide and
place the rear wheels on the floor.
4. Lift up the structure with the aspiration filter using a forklift.
Remove the pallet and place the equipment down on the
ground..
16