Technical Data; Safety Notices - LIVARNO LUX 14115702L Instructions De Montage, D'utilisation Et Consignes De Sécurité

Introduction / Safety

Technical Data

Model no: 14115702L / 14115808L /
14115902L / 14117902L
Voltage (Lamp): 230–240V∼, 50Hz
Bulb: LED module (non-replaceable)
10,5 W (14115702L /
14115902L)
12 W (14117902L)
18 W (14115808L)
Protection class: II /
Plug-in power supply (Model 14115702L /
14115902L / 14117902L)
Type: EIP012V0240PSS
220–240 V∼, 50 / 60 Hz;
0,18A;
24 V
Protection class: II /
Rated power incl.
Plug-in power supply: 12 W (14115702L /
14115902L)
12,5 W (14117902L)
Plug-in power supply (Model 14115808L)
Type: EIP020V0240PSS
220–240 V∼, 50 / 60 Hz;
0,3 A;
24 V
Protection class: II /
Rated power incl.
Plug-in power supply: 21 W (14115808L)
Safety

Safety Notices

Damage due to failure to comply with these instruc-
tions for use will void the warranty! We assume no
liability for consequential damages! We assume no
liability for property damage or personal injury due
to improper handling or failure to comply with the
safety instructions!
18 GB
max. 0,5 A
max. 0,83 A
Avoid the risk of fatal injury
from electric shock
Check the lamp for possible damage before
every use. Never use the light if it shows any
signs of damage.
CAUTION! A damaged light means danger
of death from electric shock. In the event of
damage, repairs or other problems with the
light, please contact the service centre or an
electrician.
To prevent hazards, if the external flexible lead
on this lamp is damaged it must be replaced by
the manufacturer, its service representative or
an equally qualified professional!
Before use, verify that the available mains volt-
age corresponds with the operating voltage of
the lamp.
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Always unplug the power supply from the mains
prior to assembly, disassembly, cleaning or if
the light will not be used for extended periods.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
This light is not suitable for dimmer
or electronic switches.
Prevent fire and
injury hazards
Do not look directly into the light source (light
bulb, LED etc.).
Do not look at the LED with an optical instrument
(e.g. magnifier).
The illuminant in this light is not replaceable; if
the illuminant reaches the end of its life, replace
the entire light.
Do not leave the light or packaging material ly-
ing unattended. Plastic film / bags, plastic parts
etc. are dangerous for children to play with.