Finishing; Log Placement - Napoleon Riverside GSS42CFN Manuel D'installation Et D'opération

8.1

log placement

• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delated ignition may occur.
• The logs are fragile and should be handled with care.
PHAZER logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
TM
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A
A. Place the rear log (W135-0668) onto the locat-
ing pins along the back edge of the burner.
A
B
C. Place the end of the crossover log
(W135-0672) on the right side of the knot of
log A. The "Y" in the log should straddle the
knot on top of log B.
B.
C
D.
8.0 fi nishing
A
B
Position the middle log (W135-0669) onto the
locator pins on the burner. Ensure the port
cavity on the underside of the log is positioned
such that it runs over the ports allowing them
to be exposed.
D
A
B
Place one pin into the left side of log A and one
into the left side of log B. Place the left side log
(W135-0671) onto the pins located in the left
side of logs A and B.
EN
C
17
W415-2975 / 09.02.21