Perry DECRNN032 Mode D'emploi page 50

7 - PROGRAMMABLE FUNCTIONS FOR USE WITH DIFFERENT APPLIANCES
7.5 - TOTAL DESELECTION OF ANTIFREEZE TEMPERATURE
This function allows the thermoregulation to be deactivated when operating
with the antifreeze temperature
Function on : when utilizing the antifreeze temperature
activated with a fixed factory set point of
12 °C .
F
Function off : when utilizing the antifreeze temperature
deactivated (use only for systems filled with antifreeze fluid in circuit).
To program the function, press and hold
caption 5.0c (function on)
ON
!
Press to disable the function, then press
program.
!
Press to activate the function, then press
the set program.
Note: this programmed status will not be cleared by a reset.
7.6 - SETTING THE ANTI-FREEZE TEMPERATURE
The anti-freeze temperature setting is factory set at
set a different value between
!
Keep t pressed until 5.0c
!
If the anti-freeze function is enabled (
next point, otherwise press
!
ON
Press OK and will stop blinking.
!
Set the desired value by pressing the
!
Press OK to confirm and return to the set program (fig.41).
Note: the setting will not be effected by a reset.
50
t selected.
t , thermoregulation is
5 °C , which can be set between
t , thermoregulation is
t (fig.40) until the display shows the
or 5.0c (function off) .
OFF
OK to confirm and return to the set
OK twice to confirm and return to
5 °C
4 °C and 12 °C .
blinks on the display (fig.40).
ON
will blink on the display) move on to the
to activate it.
keys.
t
2
4 and
/
DAY
R
fig. 40
Note: this function is factory set to
status and can be deactivated only in heating
mode ( winter
, however, you can
t
2
/
DAY
R
fig. 41
Note: the anti-freeze temperature setting can only be
set when in heating mode (
DAY 2
. .
. .
Auto
. .
ON
t1
t2
t3
0 2 4 6 8 10 12 14 16 18 20 22
½ h OK C
PROG /
Keep pressed for 4 sec.
"selected"
).
2
DAY
. .
. .
Auto
. .
ON
t1
t2
t3
0 2 4 6 8 10 12 14 16 18 20 22
½ h OK C /
PROG
winter ).
°
/ C t
°
C
/ t