Dremel 8220 Consignes De Fonctionnement/Sécurité page 7

1600A012FX.qxp_8220 1/30/17 12:41 PM Page 7
injury.
IMPORTANT SAFETy AND OPERATING INSTRUCTIONS
1. This manual contains instructions for
battery charger model 876. Do not substitute
any other charger.
2. Before using battery charger, read all
instructions and cautionary markings on (1)
battery charger, (2) battery pack, and (3)
product using battery.
3. Charge only Dremel rechargeable
batteries listed on page 11. Other types of
batteries may burst causing personal injury and
damage.
4. Charge battery pack in temperatures
above +32 degrees F (0 degrees C) and
below +113 degrees F (45 degrees C). Store
tool and battery pack in locations where
temperatures will not exceed 120 degrees F
(49 degrees C). This is important to prevent
serious damage to the battery cells.
5. Do not recharge battery in damp or wet
environment. Do not expose charger to rain
or snow. Water entering battery charger may
result in electric shock or fire.
6. Battery leakage may occur under extreme
usage or temperature conditions. Avoid
contact with skin and eyes. The battery liquid
is caustic and could cause chemical burns to
tissues. If liquid comes in contact with skin,
wash quickly with soap and water. If the liquid
contacts your eyes, flush them with water for a
minimum of 10 minutes and seek medical
attention.
7. Place charger on flat nonflammable
surfaces and away from flammable
materials when recharging battery pack.
Carpeting and other heat insulating surfaces
block proper air circulation which may cause
overheating of the charger and battery pack. If
smoke or melting of the charger or battery pack
is observed, unplug the charger immediately
and do not use the battery pack or charger.
Contact customer service immediately.
8. Make sure cord is located so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or stress.
Damaged plug and cord may result in electric
shock or fire.
Read and understand all instructions. Failure to follow all instructions
listed below, may result in electric shock, fire and/or serious personal
SAVE THESE INSTRUCTIONS
Charger Safety Rules
9. Disconnect the charger by pulling the
plug rather than the cord. Do not operate
charger with damaged cord or plug; have
them replaced immediately. Damaged plug or
cord may result in electric shock or fire.
10. Do not insert battery pack in charger if
battery pack case is cracked. Using
damaged battery pack may result in electric
shock or fire.
11. Do not disassemble charger or operate
the charger if it has received a sharp blow,
been dropped or otherwise damaged in
anyway. Incorrect reassembly or damage may
result in electric shock or fire.
12. Before each use, check the battery
charger, cable and plug. If damage is
detected, do not use the battery charger.
Never open the battery charger yourself,
take it to a Dremel Factory Service Center,
or qualified serviceman only using original
spare parts. Incorrect reassembly may result
in electric shock or fire.
Do not use
13.
recommended or sold by Dremel. Using
attachments not recommended may result in
electric shock or fire.
14. Do not store battery pack in charger.
Battery pack stored in charger over a long
period of time could lead to battery pack
damage and fire.
15. Unplug charger from outlet before
storage, attempting any maintenance or
cleaning. Such preventive safety measures
reduce the risk of electric shock or fire.
16. Keep the battery charger clean by
blowing compressed air on charger vents
and wiping the charger housing with a
damp cloth. Contamination may result in
electric shock or fire.
17. Replace battery pack if a substantial
drop in operating time per charge is
observed. Battery pack may be nearing the
end of its life.
7
attachments not