König SAS-WA100 Manuel De L'utilisateur page 4

Use
Water indicator
1 Normal operation
2 Water detection
3 Low-battery warning
Testing the alarm
The alarm must be tested monthly to ensure correct operation.
1. Put one finger on each sensing probe to cause a short circuit.
The alarm will sound and the indicator will flash red continuously until the test button is released.
Alarm sound: 3 short beeps, 2 seconds pause (repeated).
2. Remove your fingers from the sensing probes.
Adjusting the sensing probes
The sensing probes can be adjusted from 0 mm to 3 mm in height. Use the hex key to adjust the
sensing probe.
A
B
0-3 mm
• Turn the sensing probe clockwise to decrease the height.
The water alarm will detect the water later.
• Turn the sensing probe counterclockwise to increase the height.
The water alarm will detect the water sooner.
The indicator will flash red once every
60 seconds.
The alarm will sound and the indicator will
flash red continuously until the water is
eliminated.
The alarm will beep and the indicator will
flash red once every 60 seconds.
A
B
0-3 mm
4
English
Action: ---
Action: Eliminate
the water.
Action: Replace the
battery.