Olsberg OEC Mode D'emploi page 29

Installation steps Aracar Compact
● Tighten the motor retaining clip (6) with the spacer
sleeve onto the chassis. Push the servo-motor (5)
onto the rotation axis of the air regulator lever and
snap into the motor retaining clip (Fig.15).
● Install the door contact switch (fastening position,
see Fig.15) as described in chapter "General instal-
lation steps", step 2+3.
Fig.15
5
5 ...Servo-motor
6 ...Motor retaining clip
11 ...Door contact switch fastening position
12 ...Temperature sensor fastening position
13 ...Electronic fastening position
6 13 11
● Install the temperature sensor (fastening position on
the back side of the unit, see Fig.16) as described in
chapter "General installation steps", step 4+5.
● The remainder of the installation is performed as de-
scribed in chapter "General installation steps", step
8+10.
Fig.16
12
29