Olsberg OEC Mode D'emploi page 28

Installation steps Nuevo / Pilas
● Mount the OEC as described in chapter "General in-
stallation steps", step 1-7.
● Unscrew the supporting plate (13) for electronics
on the right side in the wood storage compartment
(Fig.13).
● Tighten the electronics to the supporting plate using
the fastening material included (Fig.14).
● Plug in all connecting cables as described in chapter
"General installation steps", step 8 and install servo-
motor according to step 9.
● Refit supporting plate with electronics on the right
side in the wood storage compartment.
Note:
When routing the cables, ensure that they are not dam-
aged or pulled out of the plug contacts.
28
Fig.13
Fig.14
13