Olsberg OEC Mode D'emploi page 26

Installation steps Ipala Compact
● Before you can install the temperature sensor and
the sensor cable, you need to remove the back
panel:
- Loosen the fastening screws (A) at the top of the
unit (by no more than 2 turns, see Fig.8).
- Loosen the fastening screws (C) at the bottom of
the unit (by no more than 2 turns, see Fig.9).
- Take off the back panel (E) (see Fig.10).
Fig.9
C
26
A
Fig.8
E
Fig.10