Olsberg OEC Mode D'emploi page 23

● Install the supporting plate included with the wash-
ers and nuts to the electronic (Fig.2).
Fig.2
● Plug in all connecting cables as described in chapter
"General installation steps", step 8.
● Install the lower front shield (8) (Fig.3). Guide the ca-
bled electronic over the lower front shield in front of
the unit in the process.
Important: To protect the bottom plate, a thin foil
can be inserted between the bottom
plate and the front shield.
Fig.3
8
● Tighten the electronics to the unit using the hex
socket head screws included (Fig.4).
Fig.4
23