Eliminate Electromagnetic Interference With The Power Line Converter; Possibility 1 To Eliminate Interferences - Cedes cegard/Lift LI Mode D'emploi

cegard/Lift LI

10.1 Eliminate electromagnetic interference with the power line converter

For wiring diagram, see Chapter 16
10.2 Possibility 1 to eliminate electromagnetic interferences
Connect a bipolar (min. 10 uF / 50 V,
polyester or polycarbonate) between
the negative pole of the power supply
and the metal case of the control unit.
Use as shor tas possible flexible cord
with outer diameter of min. 2.5 mm to
eliminate short pulse interferences.
Machine room
+
24 VDC
-
Figure 9: Possibility 1 to eliminate electromagnetic interferences
10
Control unit
+
light curtain cegard/Lift LI
-
Elevator
car
Traveling cable
English
Opto edges cegard/Lift LI
Contact set by
mounting screws
Contact is set by wire
© CEDES | V 2.7