Skil 1400 Consignes De Fonctionnement/Sécurité page 8

SM 1619X05148 10-10:SM 1619X05148 10-10 10/12/10 9:43 AM Page 8
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
For all work or when
W RNING
changing
always wear protective gloves. Such
preventive safety measures reduce the risk of
injury from sharp edges of the accessories.
Application tools can become very hot while
working. Danger of burns!
INSTALLING AND REMOVING
ACCESSORIES
1. To install accessories, align holes in
accessory with locating pins on accessory
holder in desired position. Assure that pin in
holder are engaged into holes in accessory
and securely tighten with with hex bolt
provided (Fig. 2).
Your accessories can be engaged into
accessory holder 12 positions 30 degrees
apart.
CCESSORY
HOLDER
PLUNGE CUT
BL DE
Assembly
For intermediate position an adapter is
provided that will allow you to attach the
accessory in any position. Use of adapter will
also allow you to use most competitor
accessories.
2. To remove accessory, loosen and remove
hex bolt and remove accessory from holder
accessories (Fig. 2).
First install rubber backing pad to tool. Your
tool uses hook-and-loop backed sandpaper,
which firmly grips the backing pad when
applied with moderate pressure.
To change, merely peel off the old sandpaper,
remove dust from the backing pad if
necessary, and press the new sandpaper in
place (Fig. 2).
After considerable use the backing pad
surface will become worn, and the backing pad
must be replaced when it no longer offers a
firm grip. If you are experiencing premature
wear of the backing pad facing, decrease the
amount of pressure you are applying during
operation of the tool.
HEX
BOLT
-8-
INSTALLING SANDING SHEETS
B CKING P D
D PTER
HEX BOLT
S NDING SHEET
FIG. 2
RUBBER
5 MM
HEX WRENCH