Epson TM-H6000IV-DT Manuel De L'utilisateur page 18

English
Installing/Replacing the Ribbon Cartridges
For Front Slip Printing
Follow the steps below to install/replace the ribbon cartridge for front slip printing
(ERC-32).
1. Turn on the product. (See "Turning Power On/Off" on page 17.)
2. Open the front cover. (See "Front cover" on page 17.)
3. Remove the used ribbon cartridge, if there is one.
4. Turn the knob on the ribbon cartridge a little in the direction of the arrow marked
on the cartridge to remove any slack in the ribbon. See Illustration K.
!
CAUTION:
Make sure to note the direction of the arrow marked on the ribbon cartridge when
turning the knob. If it is turned in the reverse direction, the cartridge may be
damaged.
5. Insert a new ribbon cartridge until it clicks into place. See Illustration L.
6. Turn the knob on the cartridge in the marked direction again to remove any slack
in the ribbon.
7. Close the front cover.
For Endorsement Printing
Follow the steps below to install/replace the ribbon cartridge for endorsement
printing (ERC-43).
1. Turn on the product. (See "Turning Power On/Off" on page 17.)
2. Open the receipt unit cover. (See "Receipt unit cover" on page 17.)
3. Remove the used ribbon cartridge, if there is one.
4. Turn the knob on the ribbon cartridge a little in the direction of the arrow marked
on the cartridge to remove any slack in the ribbon. See Illustration M.
!
CAUTION:
Make sure to note the direction of the arrow marked on the ribbon cartridge when
turning the knob. If it is turned in the reverse direction, the cartridge may be
damaged.
5. Insert a new ribbon cartridge until it clicks into place. See Illustration N.
6. Turn the knob on the cartridge in the marked direction again to remove any slack
in the ribbon.
7. Close the receipt unit cover.
18 TM-H6000IV-DT User's Manual