Energetics POWER RUN 2.7 Mode D'emploi page 4

Safety Instructions
To protect the floor or carpet from damage, place a mat under the treadmill.
-
Turn off the power whilst the treadmill is not in use and remove the safety key.
-
In case of emergency please place both feet at the same time on the side reins.
-
To activate an emergency stop, please detach the safety key from the console.
-
Ensure that an area of 2000 x 1000 mm behind the treadmill is free from any obstacles.
-
This product is made for home use only and tested up to a maximum body weight of 120 kilograms.
-
We take no responsibility for personal injury or damage sustained by or through the use of this treadmill.
-
The noise creation of treadmill is under 70 db.
-
The unit requires a power supply of 220V – 230V / 50 HZ.
-
The function of the immobilization method: the purpose of immobilizing the treadmill is to prevent
-
unauthorized use. This can be accomplished by removing the safety key from the console, unclipping it
from the cord and putting it in a non-accessible place.
The emergency dismount: Follow the steps listed below if you experience pain, feel faint or need to stop
-
your treadmill in an emergency situation:
1.) Grip handrails for support.
2.) Step onto the lateral platform.
3.) Pull the Safety key off the console.
The function of the emergency stop: The safety key functions as the emergency stop. In an emergency
-
situation, remove the safety key from the console and the treadmill will come to a stop.
Noise compliance: This treadmill meets the requirements of the noise pollution standards.
-
Search for noisy parts: If you should notice unusual noises, like grinding, clacking etc. try to locate it and
-
have it repaired by a professional. Make sure the treadmill is not used until after repairs have been
made.
Assembly
1. Open the carton, put the main frame on the ground.
2. Fold and move up the computer together with the uprights. IMPORTANT: When you upfoald the
computer and the uprights, make sure the metal does not damage the inside wires!
3. Fix the uprights to the lower main frame with the bolts and washers as indicated in the set up (drawing)
manual.
4. Fix the computer to the uprights with the bolts and washers as indicated in the set up (drawing) manual
Handling
Upfolding
Pull the Spring Knob until it unlocks the hole, and
gently lift the frame. Lift up the running deck and
move it into an upright position, until the Spring
Knob moves into the locking hole.
Unfolding
Pull out the spring knob from the locking hole.
Tightly fix the main frame with one hand while
unlocking the spring knob. Gently lower the
running deck to the ground.
4