Maintenance And Care; Carbon Brushes - Flex CHE 4-32 R SDS-plus Mode D'emploi

CHE 4-32 R SDS-plus
Switching on the power tool
 Press and hold down the trigger switch.
The power tool trigger switch enables
the speed or impact rate to be increased
slowly to the maximum value.
To switch off the machine:
 Release the trigger switch.
Operating instructions
Drilling/hammer drilling
1. Move the operating mode rotary knob to
the (drilling) or
symbol. Make sure it audibly clicks into
place.
2. Insert the drill bit.
3. Swivel the auxiliary handle into
the required position.
4. Insert the mains plug.
5. Grip the power tool with both hands and
assume the working position.
6. Position the drill bit and switch on the
power tool.
7. Gently press the power tool forwards.
8. After drilling, switch off the power tool.
9. Pull out the mains plug.
Chiselling
1. Insert the chisel.
2. Move the operating mode rotary knob to
the symbol.
3. Turn the chisel into the required
position.
4. Move the operating mode rotary knob to
the symbol. Make sure it audibly clicks
into place.
5. Swivel the auxiliary handle into
the required position.
6. Insert the mains plug.
(hammer drilling)
7. Grip the power tool with both hands and
assume the working position.
8. Switch on the power tool.
9. When chiselling, gently press the power
tool forwards to prevent it from jumping.
10. After working, switch off the power tool.
11. Pull out the mains plug.
Other information
– The use of "sharp" cutting accessories
increases performance and the service
life of the power tool.
– After work, clean the power tool and
store in the carrying case in a dry
location.

Maintenance and care

WARNING!
Before performing any work on the power
tool, pull out the mains plug.
Cleaning
Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use. Regularly blow out the housing interior
and motor with dry compressed air.

Carbon brushes

The power tool is equipped with cut-off
carbon brushes.
When the cut-off carbon brushes reach their
wear limit, the power tool switches off
automatically.
NOTE!
Use only original parts supplied by
the manufacturer for replacement
purposes. The use of non-original parts or
makes will invalidate any claims under the
manufacturer's warranty.
When the power tool is being used,
the carbon brushes can be seen sparking
through the rear air inlet apertures.
If the carbon brushes are sparking
excessively, switch off the power tool
immediately. Take your power tool to
a customer service centre authorised by
the manufacturer.
17