GreenWorks ELITE EPW-2000 Guide D'utilisation page 15

ASSEMBLY INSTRUCTIONS
ATTACHING THE SOAP TANK
• Align the keyhole slots with the mounting posts.
• Slide onto mounting posts and push down to hold in place.
• 5RXWH WKH GHWHUJHQW LQMHFWLRQ KRVH XQGHU WKH XQLW DQG RQWR WKH GHWHUJHQW LQMHFWLRQ KRVH ¿WWLQJ
on the back of the pump as shown.
CONNECTING THE GARDEN HOSE
C A U T I O N
Always observe all local regulations when connecting hoses to the water main. Some areas have
restrictions against connecting directly to public drinking water supply to prevent the feedback of
FKHPLFDOV LQWR WKH GULQNLQJ ZDWHU VXSSO\ 'LUHFW FRQQHFWLRQ WKURXJK D UHFHLYHU WDQN RU EDFN ÀRZ
preventer is usually permitted.
• Uncoil the garden hose.
NOTE: There must be a minimum of 10 feet of unrestricted garden hose between the water
intake and the garden hose faucet or shut off valve (such as a "Y" shut off connector).
• Run water through the hose (A) for 30 seconds to clean any debris from the hose.
• Inspect the screen in the water intake (B).
• If the screen is damaged, do not use the machine until the screen has been replaced.
• If the screen is dirty, clean it before connecting the garden hose to the machine.
• With the hose faucet turned completely off, attach the end of the garden hose to the water
intake. Tighten by hand only.
See Figure 9.
Key hole
See Figure 10.
B
A
15
Mounting post
Fig. 9
Fig. 10