GreenWorks ELITE EPW-2000 Guide D'utilisation page 18

OPERATION INSTRUCTION
• Press the switch to ON ( I ) position to start the motor.
• To stop the motor, release the trigger and press the switch to OFF( O ) position.
NOTE: The pressure washer may be on and the system may have pressure even when the
pump and/or motor cannot be heard running. Always use caution around the pressure washer.
C A U T I O N
Hold the trigger handle securely with both hands. Expect the trigger handle to move when the
trigger is pulled due to reaction forces. Failure to do so could cause loss of control and injury to
yourself and others.
NOTE: AUTO ON/OFF SWITCH: This pressure washer is equipped with an auto start/stop
feature. To operate: Set the power switch to the On (I) position. Pump will pressurize and shut
down immediately. Once the trigger of the gun is depressed, the unit will turn on. Unit will shut
off and be in standby mode when trigger is released.
USING THE SPRAY TIPS (See Figure 13)
Each of the spray tips has a different spray pattern. Before starting any cleaning job, determine
the best spray tip for the job. The following chart offers some general guidelines to help you
choose the best spray tip for your application.
127( $OZD\V WU\ VSUD\ WLS LQ DQ LQFRQVSLFXRXV DUHD ¿UVW
• Turn off the pressure washer and shut off the water supply. Pull trigger to release water
pressure.
• Engage the lock-out on the trigger handle by pushing the trigger lock button to the right.
• Pull out the desired spray tip from the tip storage on the handle.
• Pull back the quick-connect collar on the spray wand.
• Push the spray tip into place in the spray wand.
• Push the collar forward so that the spray tip is secured properly. Check to see that the spray tip
is secure.
NOTE: Make sure the faucet is turned on fully and that there are no kinks or leaks in the hose.
18
ON/OFF Switch
Fig. 12