Instrucciones De Ensamblaje - GreenWorks ELITE EPW-2000 Guide D'utilisation

INSTRUCCIONES DE ENSAMBLAJE

DESCRIPCIÓN
Lavadora a presión
Asa superior
Conjunto del panel de punta de
rociado (punta de rociado incluida).
Depósito de jabón
Pistola y varilla
Para rocío
Soporte de la pistola
Turbo Nozzle
Punta de pulverización
Tornillo
Tornillo
Ruedas
Arandelas
Manguito del eje
Pivotes de enganche
Eje de la rueda
Manuel d'instruction
Guía de inicio rápido
FIGURA
Installing the wheels WARNING: This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual before using this product. Set-up
Insert the axle through the wheel. Slide the washer over the axle pass the pin hole. 1 washer water intake. Connect garden hose to pressure
over the axle and insert the pin through the hole to firmly fasten Insert the axle and wheel through the frame. Slide the washer
the wheel assembly.
1800 PSI / 1.1 GPM 2 Assemble pressure washer gun to spray wand.
Wheel ELECTRIC PRESSURE WASHER
GPW 1800
Put pressure washer detergent in detergent tank. USING DETERGENT 3 Connect desired pressure tip.
Axle Washer Pin Install blue or black soap nozzle.
Installing the gun holder Squeeze trigger and wait approx.1 minute for soap.
Line up the screw sleeves with the holes in the upper handle
and push through. Insert the screw and turn clockwise with a Phillips head 4 Insert high pressure hose into trigger
screwdriver (not included) until the screw is tight. handle.
SPRAY TIP SPRAY TIP APPLICATION
The red 0 degree tip provides a straight line of spray. It provides the highest Red - Stream tip (0° ) 5 Connect the high pressure hose to the
0 O amount of pressure. It is best used for removing hard, stuck-on grime or dirt. water outlet connector.
Green - Narrow fan tip (25° )
The green pressure washer tip provides high versatility with its 25 degree angle tip.
25 O dirt from surfaces, but is designed to not damage many surfaces. This pressure Referred to as the washing tip, because it provides adequate pressure to remove 6 Turn on water at outlet.
washer tip is designed for "sweeping" foliage or debris given its wide angle. This tip is versatile due to its wide area of cleaning and strong pressure application.
Installing the upper handle White - Wide fan tip (40° ) The white 40 degree tip, referred to as the "fan" tip creates the widest area of
Push and hold the push-pin buttons on the sides of the upper 40 O or delicate cleaning applications. It is recommended for light cleaning on wood cleaning with relatively low pressure. This pressure washer tip is best used for light 7 Run water hose for 30 seconds with the motor in OFF position. This helps drain air
handle assembly (1) as you slide the handle onto the frame (2). decks and other soft or delicate surfaces. 30 S from the tank and lines.
(1) Black - Soap spray tip
pressure high volume for optimum performance. Soap cannot be applied under The black soap spray tip, is used for soap application. Soap is applied under low 8 Extension cord not recommended. Connect power cord to wall outlet
Push-pin (2) SOAP high pressure with this machine.
Turbo Nozzle Tip 9
The nozzle rotates in a zero to 15 degree spray pattern in a circular motion to IMPORTANT: Ensure water outlet is On Turn on Pressure Washer
break down tough dirt and grime. The spray pattern can cover area of 4 to 8 inches wide, depending on a distance between the tip and the surface being cleaned. to the pump. before turning power On to avoid damage
NOTE:
Missing parts, accessories or need a service center? AUTO ON/OFF SWITCH: This Pressure washer is equipped
Do Not Return to Store with an Auto Start/Stop feature. To operate: Turn the power switch to the On (I) position.
Call : 1-888-909-6757 Pump will pressurize and shut down immediately.
www.GreenWorksTools.com Rev:02 Unit will shut off and be in standby mode when trigger is Once the trigger of the gun is depressed the unit will turn on.
released.
10
QTD
1
1
1
1
1
1
1
1
1
2
4
2
2
2
2
2
1
1