Adjusting Switch Points And Hystereses; Switching Outputs; Switching Window - Hydac HDA 5500 Notice D'utilisation

HDA 5500 for HLB 1000 and CS 1000

11 Adjusting switch points and hystereses

•
During normal operation, press mode key.
•
Depending on the settings SP (switch points) or Win (switching window) will be displayed
Note:
If the mode key is pressed for longer than approximately 5 s, then the Basic Settings Menu
will be activated!

11.1 Switching outputs

Procedure for HDA 5500 with switching output set to switch point and hysteresis mode:
•
During normal operation, press the mode key. SP (switch point) is then displayed.
•
As soon as the mode key is released, S.P.1 (switch point 1) is displayed.
•
After approx. 2 s the display changes and the pre-set switch point flashes in the display.
•
If the mode key is pressed again, hYS.1 (hysteresis 1) appears in the display.
•
Keep pressing the mode key to display S.P.2 (switch point 2) and hYS.2 (hysteresis 2),
S.P.3 (switch point 3) and hYS.3 (hysteresis 3), S.P.4 (switch point 4) and hYS.4
(hysteresis 1) one after the other.
•
If a switch point or hysteresis is shown flashing, the setting can be changed by pressing
or within approximately 3 s.
•
If or is not pressed for approximately 3 s or longer, then the display returns to
normal operation. Any altered settings are saved at the same time.
mode
Press mode key Release mode key

11.2 Switching window

Procedure for HDA 5500 with switching output set to switching window:
•
During normal operation, press the mode key. Win (switching window) appears.
Note: If mode is held down longer than approximately 5 s, then the menu for basic
settings is activated!
•
As soon as mode is released, Hi.1 (upper switch point 1) is displayed.
•
After approximately 2 s the display changes and the pre-set switch point is shown
flashing.
•
If mode is pressed again, Lo.1 (lower switch point 1) is shown.
•
Keep pressing mode to display Hi.2 (upper switch point 2) and Lo.2 (lower switch point
2), Hi.3 (upper switch point 3), Lo.3 (lower switch point 3), Hi.4 (upper switch point 4) and
Lo.4 (lower switch point 4) one after the other.
•
If an upper switch point or a lower switch point is shown flashing, the setting can be
changed by pressing
•
If or are not pressed for longer than approximately 3 s, then the display returns to
normal operation. Any altered settings are saved at the same time.
or within approximately 3 s.
mode
Use the
keys
or
to change the setting
- 24 -