Time Setting; Alarm­setting - Grundig MF 2000 BT Mode D'emploi

SeTTInGS
Time­Setting
1
To set the time, your micro system must be in
standby mode first. Then press and hold the
ClOCK
» « button for about 2 seconds.
– Display: » 24 H «.
2
Select the time format (12 or 24 hours) by
pressing button »
with the » ClOCK
– Hours tick.
3 Select the time by pressing button »
or » « and confirm using the »
button.
– Minutes tick.
4
Set the minutes by pressing button »
or » « and confirm using the »
button.
– Display: current time.
– SYNC ON: The time is synchronized through
RDS signal.
– SYNC OFF: The time isn't synchronized
through RDS signal.
notes:
Some RDS stations transmits an RDS time
7
signal. If the selected RDS station transmits
time information, the time can be set auto-
matically.
Press » InFO « repeatedly until the time is
displayed. The » RDS CLK « display means
that the time signal is not yet received. Wait
for the time to display.
The time must be reset after a power outage
7
or after disconnecting the device from the
main line.
­ - --------------------------------------------------------------------------------------------------------------------------------------
« or » « and confirm
« button.
ClOCK
ClOCK
alarm­Setting
1
To program the alarm, your micro system
must first be in standby mode. Then press the
TIMeR
» « button on your remote control and
hold it down for about 2 seconds.
– Display: » TIMER «.
2
Proposal and display of the different
alarm programs: » disC », » USB « or
» TuneR «. Press the button »
and confirm using the »
«
– Hours tick.
«
3 Select the time by pressing button »
» « and confirm using the »
ton.
«
– Minutes tick.
«
4
Set the minutes by pressing button »
» « and confirm using the »
ton.
– Volume settings blink.
5 The volume displays » VOL 10 «. Adjust the vol-
ume by pressing button »
confirm using the »
– You can adjust the volume between
» VOL 01 « and » VOL 31 «.
– You can adjust the alarm duration among
"DUR 15, DUR 30, DUR 45, DUR 60''.
¥
6 The symbol »
screen of the minutes to confirm the program-
ming of the alarm.
note:
If you want to disable the alarm, press the
7
» TIMeR « button on the remote control
once and the alarm symbol »
appear from the screen.
« or »
TIMeR « button.
TIMeR
TIMeR
« or »
TIMeR
« button.
« will then display on the right
¥
« will dis-
ENGLISH
«
« or
« but-
« or
« but-
« and
13­