Tuner­mode; Radio­stations - Grundig MF 2000 BT Mode D'emploi

TUneR­MODe
automatic­ station­ search­ for­ FM­
radio­stations
After connecting the hi-fi system to the mains
power for the first time, you can start the auto-
matic station search.
1
Switch on the hi-fi system by pressing »
the device or » « or »
mote control to switch to the FM mode.
2
Activate the automatic station search by
pressing and holding »
– The device searches for up to 40 stations
with strong reception and stores them auto-
matically. After the search has finished, you
will hear the station stored at preset 01.
notes:
You can cancel the automatic station search
7
by pressing » «.
Setting­and­storing­radio­stations­
manually
1 Set the radio station by briefly pressing
» TUne+ « or » TUne-
– Display: the frequency changes in steps of
50 kHz;
or
press and hold down »
TUne-
» « until the frequency changes to rap-
id run-through.
2 Save a radio station as a preset by
pressing » MeMORY/PROG
lecting the preset
» « and then press »MeMORY/PROG«
to save.
3 To search and save more radio stations, repeat
steps 1 to 2.
10­
ENGLISH
­ - -----------------------------------------------------------------------------------------------------------------------
«­on
SOURCe
« on the re-
«.
« repeatedly.
TUne+
« or
«, se-
with » « or
Selecting­the­tuner­input­source
1­Select the TUNER input source by pressing
»SOURCe« on the remote control.
– The most recently selected station is played
(Last Station Memory).
Selecting­presets
1 Select a preset by pressing »
the remote control to switch to the FM mode.
Displaying­ RDS­ station­ informa-
tion
If the device receives an RDS station, the station
name appears in the display together with »RDS«.
If no information is available, the reception frequen-
cy appears in the display.
Additional information can be displayed.
1 To display information on the current RDS sta-
tion, press »InFO« repeatedly.
– The following displays appear in sequence:
The name of the radio station.
The current programme type (PTY), e.g.
»Pop music«. »[No PTY]« appears if infor-
mation is not available.
The time.
The radio text.
The frequency.
eCO­Mode
The hi-fi system switches to standby in the ECO
mode after 15 minutes. This lowers the power
consumption to below 0.5 W.
1 In ECO mode, press »ClOCK« once.
– The clock is displayed. The device switches
back to ECO mode after 15 minute.
2­In ECO mode, press and hold down »
two seconds.
– The device switches to standby, the clock is
displayed.
– The device switches back to ECO mode after
15 minutes.
« or » « on
« for