mspa Mont Blanc Mode D'emploi page 24

PROBLEM
OZONATOR
FAILURE
FILTER PUMP
DOES NOT WORK
SPA TUB IN AN
ABNORMAL
SHAPE
SPA LEAKING
SPA LOSES AIR
PRESSURE
WATER NOT
CLEAN
CONTACT YOUR LOCAL MSPA DEALER OR SERVICE CENTER FOR ANY PRODUCT RELATED QUESTIONS OR PROBLEMS.
CAUSE
Water level is below the minimum
water line
One-way valve blocked
Filter pump does not work
Filter stuck by dirt or other objects
Filter system failure
Extra air pressure by strong
sunlight
securely tight
Drainage valve is not closed
completely
Water leaks from the spa pool body
Air valve got loosen
Hole or split on the spa tub
Water has been used too long
Insufficient filtering
Dirty filter cartridge
Improper water maintenance
Add water above the minimum line
Contact the MSpa Service Center
section
Clean or replace the filter cartridge
Contact the MSpa Service Center
Check the air pressure and release some air
if necessary.
During hot weather, it is recommended to
check if it is necessary to release some air to
avoid any possible damage to the spa pool
Tighten the inlet and outlet connection
Close the drainage valve. Contact the MSpa
Service Center, if spa is still leaking
the repair kit material
Inflate the spa till the Yellow section of the
manometer is pushed out. Make sure the
valve is screwed tightly. Replace the valve if
necessary.
Put soap water in a squirt bottle and spray
on seams. If there is a leak, small bubbles
will come out. After you find the leak, clean
and dry the leaking area, then use the repair
patch comes with your spa to repair. Check
the repair section on P22.
Change the water
Increase filtration frequency
Clean or replace the filter cartridge in time
Refer to the chemical manufacture's
instruction
24
SOLUTION