Stop The Snow Thrower; Check The Oil (Before Starting Engine); Traction Lock Pins - Sears C950-52943-0 Manuel D'utilisation

OPERATION
WARNING: Read Operator's Manual before operating
machine. This machine can be dangerous if used
carelessly.
• Never operate the snow thrower without all guards,covers,
shields in place.
• Never direct discharge towards windows or allow
bystanders near machine while engine is running.
• Stop the engine whenever leaving the operating
position.
• Disconnect spark plug before unclogging the impeller
housing or the discharge chute and before making
repairs or adjustments.
• When leaving the machine, remove the safety key. To
reduce the risk of fire, keep the machine clean and free
from spilled gas, oil, and debris.

STOP THE SNOW THROWER

1. Release the traction drive clutch lever (B B , Figure 15).
2. Push the ON/OFF switch (A A , Figure 22) to the OFF position and pull out the
safety key (B B ).

CHECK THE OIL (BEFORE STARTING ENGINE)

NOTE: The engine was shipped from the factory filled with oil.
Check the level of the oil. Add oil as needed.
1. Make sure the unit is level. Use a high quality detergent oil classified
"For Service SF, SH, SJ, SL, or higher".
2. Remove the oil fill cap/dipstick (A A , Figure 17) and wipe with a clean cloth.
3. Insert the oil fill cap/dipstick and turn clockwise to tighten.
4. Remove the oil fill cap/dipstick and check the oil.
NOTE: Do not check the level of the oil while the engine runs.
5. If necessary, add oil until the oil reaches the FULL mark on the oil fill
cap/dipstick. Do not add too much oil.
6. Tighten the oil fill cap/dipstick securely each time you check the oil
level.
NOTE: For extreme cold operating conditions of 0°F (-18°C) and
below, use a synthetic 5W30 motor oil for easier starting.
NOTE: S.A.E. 5W30 motor oil may be used to make starting
easier in areas where the temperature is 20°F (-7°C) to 0°F
(-18°C). Synthetic 5W30 is acceptable for all temperatures.
DO NOT mix oil with gasoline. See Chart for oil recommenda-
tions.

TRACTION LOCK PINS

The right traction wheel can be completely released using the locking pin
(A A , Figure 16). This allows the unit to be easily moved with the engine off.
A
Traction Lock Pins
* Below 40°F (4°C) the use of SAE 30 will result in hard starting.
** Above 80°F (27°C) the use of 10W-30 may cause increased oil consumption. Check
oil level more frequently.
A
Checking the Oil
18
Figure 16
FULL
Figure 17