Upper Handle And Crank Assembly; Set The Length Of The Cables - Sears C950-52943-0 Manuel D'utilisation

ASSEMBLY

UPPER HANDLE AND CRANK ASSEMBLY

1. Loosen, but do not remove the screws, flatwashers, lockwashers, and
hex nuts in the upper holes of the lower handle (see Figure 4).
2. Remove the fasteners and the crank assembly eyebolt from the lower
holes of the lower handle.
3. Raise upper handle into operating position. Upper handle should be to
the outside of the lower handle.
NOTE: Make sure the cables are not caught between the upper and
lower handle.
4. Install the fasteners and the crank assembly eyebolt that were removed
in step 2. DO NOT tighten until all fasteners are in place.
5. Attach the crank rod (A A , Figure 5) to the universal joint assembly (B B )
with the hair pin (C C ).
6. Tighten nut on eye bolt. Make sure eye bolt is properly aligned and the
crank can freely rotate (see Figure 4).
7. Tighten all handle bolts.
NOTE: Make sure crank does not touch carburetor cover.
CHECK THE CABLES
1. If control cables have become unattached from motor mount frame, re-
connect cables as shown in Figure 6.
2. For cable adjustments, see "Check and Adjust the Cables" in the
MAINTENANCE section.

SET THE LENGTH OF THE CABLES

The traction drive and auger drive cables (A A and B B , Figure 6) were adjusted
at the factory and no adjustments should be necessary. However, after the
handles are put in the operating position, the cables can be too tight or too
loose. If an adjustment is necessary, see "Check and Adjust the Cables" in
the MAINTENANCE section.
Adaptor Boot
Flatwasher
Crank
Eye Bolt
Upper Handle Assembly
Crank Assembly
A
Check the Cables
12
Lockwasher
Nut
Locknut
Flatwasher
Flatwasher
C
A
B
B
Bolt
Figure 4
Figure 5
Figure 6