Sears C950-52943-0 Manuel D'utilisation page 14

ASSEMBLY
SNOW CHUTE ASSEMBLY
NOTE: The chute ring assembly (A, Figure 10) comes installed on the unit
from the factory.
1. Turn crank assembly (Figure 4) until the arrow on outer ring (B B , Figure
10) of chute ring assembly points forward.
NOTE: Make sure the slot in the chute ring aligns with the arrow on the
outer ring.
2. Install chute deflector (C C ) using four screws (D D ) and nuts (E E ) in holes
as shown. The chute deflector must point forward for proper installa-
tion.
3. Tighten screws snugly but be careful not to over-tighten.
HEADLIGHT ASSEMBLY
The headlight is mounted on the right side of the upper handle. It is in-
stalled upside-down for shipping purposes.
1. Remove the nut (A A , Figure 11) and lockwasher (B B ) from the carriage
bolt (C C ).
2. Turn the headlight (D D ) to the top side of the upper handle (E E ). Ensure
external tooth lockwasher (F F ) and saddle washer (G G ) are in place as
shown in Figure 11.
3. Install the nut and lockwasher to secure the headlight to the handle.
The headlight should point toward the snow clearing path.
C C
D
E
Snow Chute Assembly
D
B
A
Headlight Assembly
14
B
A
Figure 10
C
E
F
G
Figure 11