Speed Select Lever Assembly - Sears C950-52943-0 Manuel D'utilisation

SPEED SELECT LEVER ASSEMBLY

1. Cut plastic tie (A A , Figure 7) securing speed select lever assembly (B B )
to the shifter bracket (C C ).
2. Remove locknut (A A , Figure 8), washer (B B ), spring (C C ), and bolt (D D ).
NOTE: View is from right side of unit standing in operator's position.
3. Position speed selector lever assembly as shown in Figure 9.
4. Reinstall bolt (D D , Figure 8), spring (C C ), washer (B B ) and locknut (A A ).
5. Tighten locknut until 1/8 to 3/16 inch of the bolt threads protrude past
the locknut.
6. Thread the 3/8-16" hex jam nut (E E ) onto the lever (F F ) until the nut
reaches the end of the thread.
7. Thread the plastic knob (G G ) as far as possible and ensure that the knob
points forward.
8. Tighten the 3/8-16" hex jam nut against the knob securely.
9. Move shifter through all speeds to ensure proper tension of the spring.
If shifter lever sticks in any of the notches, loosen locknut 1/2 turn at a
time until shifter lever moves more freely.
C
A
B
Shift Lever and Bracket
D
Shifter Handle
Control Panel
Control Panel and Shifter Bracket
Figure 7
13
G
E
F
A
1/8 to 3/8 inch of
exposted thread
C
ASSEMBLY
B
Figure 8
Shifter Bracket
Figure 9