Red Sea ReefDose Notice D'utilisation page 27

Red Sea ReefDose ®
from giving you notifications that communication with the unit has been lost. When returning the
unit and/or switching it back on, remember to return its status to "In-service".
ENG
To change the status: Device Manager > Device Line menu > In-service / Out-of-service.
Removing a ReefDose - Permanent
When permanently removing a ReefDose from an aquarium or before resetting the unit's memory,
delete the unit from the ReefBeat App:
Device Manager > Device Line menu > Delete.
Deleting before it is switched off will prevent unnecessary notifications that communication with the
unit has been lost.
Rebooting the ReefDose
In some cases, such as when the ReefDose disconnects from the ReefBeat cloud, it will be necessary
to restart the device. This can be done in 2 ways.
Click the Reboot button from the device manager: Device Manager > Device Line menu > Reboot.
Alternately, you can disconnect and reconnect the power by the DC jack and wait for the ReefDose
to reboot.
Clear ReefDose settings
To permanently remove all user settings from the memory of the ReefDose and return it to its initial
default state, perform the following steps.
If the ReefDose is connected to ReefBeat the factory reset can be activated from the App: Device
Manager > Device Line menu > Hard Reset.
If the ReefDose is not connected to ReefBeat perform the following steps:
Permanently remove (Delete) the specific ReefDose from ReefBeat.
Press the Settings button for about 15 seconds (until the indicator LED shows a double blink), release
the button and wait for about 60 seconds until a second double blink of the indicator LED appears.
Disconnect and reconnect the power by the DC jack and wait for the ReefDose to restart.
The unit will restart without any user settings, exactly as shipped from the factory. The unit will retain
the latest installed version of the firmware.
27