Spare Parts; Environmental Notice - Benning MM 7 Mode D'emploi

9.5 Calibration
To maintain the specified precision of the measurement results, the instrument
must be recalibrated at regular intervals by our factory service. We recom-
mend a recalibration interval of one year. Send the appliance to the following
address:
Benning Elektrotechnik & Elektronik GmbH & CO. KG
Service Centre
Robert-Bosch-Str. 20
D - 46397 Bocholt

9.6 Spare parts

Fuse F 10 A, 500 V, D = 6.35 mm, L = 32 mm, P.no. 749726
Fuse F 1 A, 500 V, D = 6.35 mm, L = 32 mm, P.no. 749669
10. How to use the protective rubber holster
- The safety test leads can be stored by coiling them round the protective
rubber holster  and clipping the probe into the holster  so that they are
sufficiently protected (see fig. 14)
- You can clip one lead onto the protective rubber holster  in such a way
that the measuring probe projects. This allows you to bring the measuring
probe and the BENNING MM 7 up to the measuring point together.
- The support at the back of the holster  can be used to prop the
BENNING MM 7 up in a diagonal position (to make reading easier) or to
suspend it (see fig. 15).
- The protective rubber holster  has an eyelet for suspending the unit in a
convenient position.
See fig. 14:
See fig. 15:
11. Technical data of the measuring accessories
4 mm Safety measuring cable ATL 2
- Standard: EN 61010-031,
- Maximum rated voltage to earth ( ) and measuring category: 1000 V
CAT III, 600 V CAT IV,
- Maximum rated current: 10 A,
- Protective class II (  ), continuous double or reinforced insulation,
- Contamination class: 2,
- Length: 1.4 m, AWG 18,
- Environmental conditions:
Maximum barometric elevation for making measurements: 2000 m,
Temperatures: 0 °C to + 50 °C, humidity 50 % to 80 %
- Only use the measuring cables if in perfect condition and according to this
manual, since the protection provided could otherwise be impaired.
- Throw the measuring cable out if the insulation is damaged or if there is a
break in the cable/ plug.
- Do not touch the bare contact tips of the measuring cable. Only grab the
area appropriate for hands!
- Insert the angled terminals in the testing or measuring device.

12. Environmental notice

At the end of the product's useful life, please dispose of it at
appropriate collection points provided in your country.
11/ 2008
Wrapping up the safety test leads
Standing up the BENNING MM 7
BENNING MM 7

20