Klarstein 10035466 Mode D'emploi page 22

EN
22
Installation (Vent outside)
Note: When the range hood and appliance supplied with energy other than
electricity are simultaneously in operation, the negative pressure in the room must be
not exceed 4 Pa (4 x 10
1
Drill 3 x 8 mm holes to accommodate the
bracket. Screw and tighten the bracket
onto the wall with the screws & screw
plugs provided.
3
Put the upper chimney into lower
chimney. Then pulling out the upper
chimney upwards. Adjust to reach the
height required.
-5
Bar).
Offer up the cooker hood and hang onto
the wall bracket hook.
Screw and tighten the upper and lower
brackets onto the wall with the screws &
screw plugs provided.
2
4