Installation; Preparation - Klarstein 10035466 Mode D'emploi

EN
20

INSTALLATION

Assembly of the V-flap
If the cooker hood does not have a pre-assembled V-flap, install the parts as follows:
1 Install the first half (2) in the housing (6).
2 The pin (3) should be facing upwards.
3 Insert the axle (4) into the holes (5) on the housing.
4 Repeat all steps for the second half of the flap.

Preparation

If you have an outlet to the outside, your cooker hood can
be connected as below picture by means of an extraction
duct (enamel, aluminium, flexible pipe or inflammable
material with an interior diameter of 150 mm).
• Before installation, turn the unit off and unplug it from
the outlet.
• The cooker hood should be placed at a distance of
65~75 cm above the cooking plane for best effect.