Led Status Indicators - Lindy 32338 Manuel Utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

User Manual
Installation
Note: If you experience problems with mouse functionality, try using the same brand and
model of mouse on both local and remote units.
Make sure all of your computers and peripherals are switched OFF before proceeding with the
installation.
Local Transmitter Unit
1. Connect your keyboard, mouse and monitor to the Local Console ports on the Transmitter.
2. Using a 2-in-1 USB KVM cable, connect the ports labelled PC / KVM on the Transmitter
unit to the USB and video ports on your computer, or the USB and video control console
ports on your KVM switch.
3. Connect a CAT5 (or higher) network cable of appropriate length to the RJ-45 port
Remote Receiver Unit
1. Connect your USB keyboard, mouse and monitor to the ports on the Remote unit.
2. Using the supplied 2-in-1 KVM cable, connect the USB and video ports labelled LOCAL PC
to the USB and video ports on your local PC.
3. Connect a CAT5 (or higher) network cable to the RJ-45 port
4. Connect the power supply jack to the port on the Remote unit. Plug the power supply into
the mains
Powering up and checking the installation
1. Power on the PC connected to the Remote Receiver unit and then power on the PC / KVM
Switch installation connected to the Local Transmitter unit.
2. Check the display quality at the Remote Receiver console. Rotate the VGA Tuning control
to adjust the picture quality. If this does not provide a good enough picture quality you may
get better results with higher quality CAT6 network cable. The picture quality of any CAT5
Extender degrades with increasing cable length. Up to a resolution of 1280x1024@80Hz
and a cable length of 100m there should be no significant shadows, but a more or less
clear picture. For higher resolutions this distance is reduced. For lower resolutions the
picture quality may also be acceptable over longer cable lengths.

LED Status Indicators

LED
STATUS
LOCAL
RED
FLASHING
LOCAL
RED
REMOTE
RED
FLASHING
REMOTE
RED
LED
STATUS
POWER
OFF
POWER
RED
FLASHING
STATUS
RED
STATUS
OFF
Remote Receiver Unit
MEANING
The console is switched to the local workstation PC
The console is switched to the workstation, but the PC is turned off or
not connected.
The console is switched to the remote computer / KVM Switch
The console is switched to the remote computer / KVM Switch but the
computer(s) are not connected or are switched off.
Local Transmitter Unit
MEANING
No computer(s) or KVM switch connected to the Local Transmitter.
Computer(s) or KVM switch connected to the Local Transmitter.
Flashes when there is local console keyboard/mouse activity.
When there is no console keyboard/mouse activity this LED remains off.
4
English

Publicité

Table des Matières
loading

Table des Matières