User Manual
Keyboard hotkey commands (Remote Receiver only)
Both consoles of the extender can have simultaneous access to the connected server or KVM
switch. Active keyboard and mouse access is governed by a short timeout period.
When you access from the local console of the Transmitter unit you can operate your USB KVM
switch using its regular keyboard hotkeys. When you use the remote console you have two
additional hotkeys that allow you to switch between your workstation and remote KVM access.
You can switch console control at the Remote Receiver unit from PC port (connected
workstation) to RJ-45 port (the PC / KVM switch connected to the Local Transmitter) using this
simple hotkey command:
Scroll
+
Lock
When switching, the appropriate LOCAL and REMOTE LED will light on the Remote unit. You
will also hear an audible confirmation. You can enable and disable this audible beeper using
this hotkey command:
Scroll
+
Lock
Troubleshooting
There are no LED's illuminated on the Remote Receiver unit
Ensure that the AC Adapter is plugged into the mains and the jack is plugged into the
socket on the Remote Receiver.
Verify that the connected PC is switched on. Otherwise display problems may result.
There is no video signal displayed on the monitor
Check that the VGA cables and CAT5 cable are properly connected to the respective
ports on the Receiver and Transmitter units.
Ensure the VGA cables are correctly connected to the computers.
Make sure the computer is not in Stand-by mode or powered down.
Make sure the power adapter is connected to the Receiver
If you still can't see a picture, try connecting with a shorter CAT5 patch cable to make sure
there is not a fault with the longer CAT5 cable.
The display is 'foggy' or unclear.
Check that the VGA cables are properly connected.
Try adjusting the VGA Tuning control as described in the Installation section
Ensure that the VGA resolution is not set too high for the length of Ethernet cable that is
used.
Try a higher specification or shorter length CAT6 cable
Try reducing the display resolution
If results are still not satisfactory please refer to the final remarks in the Installation section
Scroll
+
C
Lock
Scroll
+
Q
Lock
= select 'PC Port' or 'RJ-45 Port' (Remote KVM access)
= Beeper ON/OFF
5
English