Using The Remote Control - Sharp FU-21SE Manuel D'utilisation

Masquer les pouces Voir aussi pour FU-21SE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
2
Install the filter
1
Remove the HEPA filter from
the polyethylene bag and install
it in the main unit with the
display facing up.
Insert so that the tabs on the HEPA filter are fac-
ing toward you.
Proper operation cannot be achieved when install-
ing the filter backwards.
2
Remove the deodorization filter
from the polyethylene bag and
install it in the main unit.
Make sure the tabs on the HEPA filter remain vis-
ible.
3
Install the filter support
Tab(2places) of the upside is inserted into the hole
part on the body. Next, the tab(2places) of the bot-
tom side is pushed.
4
Fill in the usage start date on
the replacement label affixed
on the back of the front panel
and then mount the front panel.
Use the date as a guide for the filter replacement
period.

USING THE REMOTE CONTROL

• Operate the remote control facing the main unit (re-
ceiver).
• The signal range is about 7m (front).
• Make sure there are no objects blocking the path of the
signal.
• A sound will be heard from the main unit when a signal
is received.
NOTE
• Avoid strong impact on the remote control. In addition,
do not wet the remote control or place it under direct
sunlight or near a stove, etc. Malfunction may occur as
a result.
HEPA filter
Deodorization filter
Filter support
Tab of the
up side
Replacement label
Receiver
E-7
Tabs
Tab of the
bottom side
Transmitter

Publicité

Table des Matières
loading

Table des Matières