Erbauer ERN642ATL-I Mode D'emploi page 12

ADJUSTMENT OF CUT DEPTHS
This tool features an adjustable work guide (B)
to set cut depths. Follow the steps below to
adjust the cut depths.
WARNING! Always disconnect
the tool from the air supply before
you are adjusting the cut depths
of tool.
1. Loosen the set screw (D) with the provided
hex key (J) by turning counterclockwise.
(See Figure 9)
2. Pull out or push back the work guide (B)
with hand to the desired extension to adjust
the cut depths. (See Figure 10)
3. Retighten the set screw (D) with the hex key
(J) by turning clockwise. Make sure that the
saw blade is fixed tight and secure.(See
Figure 11)
NOTE: The more length of the work
guide (B) is extended, the less cut
depth the tool does.
AIR BODY SAW