LGB 28004 Instructions De Service page 8

supplies will void your warranty.
Use this model with LGB power supplies
with an output of at least 1 amp. For
more information on LGB power sup-
plies for indoor, outdoor and multi-train
operation, see the LGB catalog.
Attention! After extended operation, this
model may leave carbon dust or other
debris around the track. This dust and
debris can stain carpet and other mate-
rials. Consider this when setting up your
layout. Gebr. Märklin are not liable for
any damages.
SERVICE
Do-It-Yourself Service Levels
Level - Beginner
Level - Intermediate
Level - Advanced
Attention! Improper service will void your
warranty. For quality service, contact
your authorized retailer or an LGB factory
service station (see Authorized Service).
Lubrication
The side rod ends should be lubricated
occasionally with a small amount of LGB
Maintenance Oil (50019).
Cleaning
This model can be cleaned externally
using a mild detergent and gentle stre-
am of water. Do not immerse this model.
Attention! This model is equipped with
sound electronics. Do not expose the
speaker directly to water.
Replacing the light bulbs
Front lower lanterns: Pull the lantern
housing away from the model. Remove
and replace the bulb. Reassemble.
Front upper and rear lower lanterns:
Remove the ring around the lantern lens.
Carefully pry the lens away from the lan-
tern. Using tweezers, remove and repla-
ce the bulb. Reassemble.
Rear upper lantern: Carefully pull the wires
down to remove the light socket from
the lantern. Replace the bulb. Reassemble.
8
Cab light: Using tweezers, remove and
replace the bulb.
Replacing the
smoke generator
- Pull the safety cover out of the smoke
stack (Fig. 3).
- Pull the smokebox front out of the boi-
ler (Fig. 4).
- Unplug the wires for the old smoke
generator from the circuit board inside
the boiler.
- Push the old generator out of the smo-
kestack.
- Push the replacement generator into
the stack and plug the wires into the
loco circuit board.
- Reassemble.
Replacing the traction tire
- Remove the hex screw on the wheel
with the traction tire and remove the
side rod.
- Use a small, straight-blade screwdri-
ver to pry the old traction tire out of the
wheel groove.
- Use a small, straight-blade screwdri-
ver to gently pry the new traction tire
into the wheel groove.
- Make sure that the traction tire is sea-
ted properly in the wheel groove.
Maintenance parts
50010 Smoke and Cleaning Fluid
50019 Maintenance Oil
51020 Gear Lubricant
55020 MTS Decoder
62210 28001-Series Motor
63120 Brushes, Assembled,
14 mm and 16 mm,
8 pieces
65853 Smoke Generator, 5V
68511 Plug-In Bulb, Clear, 5 V, 10 pieces
69104 Traction Tire, 37.5 mm, 10 pieces