Maintenance; Accessories - Storch 570350 Traduction Des Instructions D'origine

Plunge cuts
Plunge cuts may only be made in soft materials such as wood or plastic. Only
use short saw blades. Hold the machine with both hands on the hand grips
provided, take up a secure position and concentrate while working.
The machine is pressed against the part with the edge of the limit stop (13).
The saw blade does not touch the part. Switch on the machine. The corner of
the limit stop serves as a pivot around which the machine is slowly raised and
the saw blades cuts into the part.

Maintenance

Regularly blow out the machine through the engine / ventilation passages with
compressed air.
Clean regularly: Press the button (12) and remove the limit stop (13). With the
saw blade remove, hold the appliance pointing vertically downwards and knock
lightly on the machine with your hand. The accumulated dust will fall out. Do
not oil or grease.

Accessories

Only use original STORCH accessories (see final page).
Only use accessories which fulfil the requirements and identification data spe-
cified in these operating instructions.
Translation of the original instruction 92