Use - Storch 570350 Traduction Des Instructions D'origine

Use

Multifunctional monitoring system for the machine
If the machine switches of independently, this means that the electro-
nics have activated the self-protection mode.
Causes and remedies
1. Battery pack almost empty (the
electronics protect the battery back
from damaged caused by the battery
being completely discharged).
2. Overloading the machine for an
extended period of time may lead to
a temperature shutoff.
3. The machine switches off if
the current is too high (e.g. with a
long-lasting blockage).
Battery pack
Charge the battery back before use. Charge the battery pack again if perfor-
mance drops. The optimal storage temperature is between 10° C and 30° C.
„Li-Power, LiHD" lithium ion battery packs have a capacity and signal indicator
(9):
- Press the button (8), the LEDs indicate the charge level.
- The battery pack is almost flat and must be recharged if one LED is flashing.
Removing: Press the button for unlocking the battery pack (6) and remove the
battery pack (7).
Inserting: Push the battery pack (7) in until it clicks into place.
Inserting, removing saw blade
Before performing any work on the machine: remove the battery pack.
Do not touch the saw blade immediately after it has been used
as it may be extremely hot and this could lead to skin burns.
Reciprocating saw blades should generally be used.
If the battery pack is empty, it must
be charged again!
Allow the machine or battery pack to
cool down. Note: The machine cools
down more quickly if it is left to run
at idling speed.
Switch off the machine using the
trigger switch (10). Then continue to
work again. Avoid further blockages.
89 Translation of the original instruction