Technical Specifications - Storch 570350 Traduction Des Instructions D'origine

Technical specifications

U
n
0
s
m
ah, B/Kh, B
ah, WB/Kh, WB
L /K
pA pA
L /K
WA WA
U = Battery pack voltage
n0 = Stroke rate at idle speed
Vibration total value (vector sum from three directions) determined as per EN 60745:
ah, B = level of vibration (sawing chipboard 38 mm)
Kh = Shakiness (vibration) (sawing wood 100 x 100 mm)
Typical A-weighted sound level: LpA = sound pressure level
LWA = sound power level
When working, the noise level can exceed 80 dB(A).
All information is without guarantee! Subject to technical modifications
and errors!
Wear hearing protection!
Direct current
The technical data specified have tolerance (according to the respective valid
standards).
Emission values
This values make it possible to estimate the emissions from the electric power
tool and to compare different electric power tools. Depending on the operating
conditions, the state of the electric power tool or the use of tools, the actual
load may be higher or lower. Breaks from work and phases with lower loads
must be taken into account in the estimation. Define protective measures for
the user based on corresponding adjusted estimates, e.g. organisational mea-
sures.
V
/min (spm)
mm (in)
kg (lbs)
m/s
2
m/s
2
db(A)
db(A)
s = stroke length
m = weight (with smallest battery pack)
Measuring values determined as per
EN 60745.
KpA, KWA = shakiness
83 Translation of the original instruction
18
0 - 3.100
13 (1/2)
1,7
10 / 1,5
9 / 1,5
80 / 3
91 / 3