Teka HPL-870 Guide Rapide D'utilisation page 45

Pre-heating is not needed for the other
recipes.
Follow these instructions when cooking with
these recipes:
• First select the recipe, and the oven will
begin pre-heating.
• IMPORTANT: Do not put the food into the
oven until the signal is given.
Child Safety Function
This function, which can be selected at any
time, stops small children operating the oven.
To activate this function, touch both the + and
– sensors at the same time until you hear a
beep. You will see the symbol
the temperature display. The oven is locked.
To de-activate this function, touch both the +
and – sensors at the same time until you hear
a beep, with the symbol
Programming and operating the pyrolytic function
Follow the instructions below to run a pyrolytic
cleaning cycle:
1. IMPORTANT: Remove all accessories
(trays, grids, side supports for the
shelves, telescopic guide rails) from
inside the oven.
2. Touch the sensor
on.
Other oven settings
light up on
going out.
to switch the oven
• When the temperature set for the recipe is
reached, the oven will emit a signal.
• You can now put the food into the oven.
• The signal will continue to sound until you
put the food in.
• Finally, it will cook the food automatically
according to the recipe chosen.
Oven Light
The inside light will go on:
• When the oven door is open. If the door is not
closed after a certain amount of time, the
light will turn off
consumption.
• When any cooking function is set or recipe
selected. The light will turn off after a
certain time.
If you want to turn the light on during cooking,
just touch the + sensor. Touching it for a
certain length of time will cause it to beep and
the light will stay on all the time it is cooking.
To turn the light off, just touch the + symbol
again.
3. Turn the cooking control dial until you see
the word Piro and the setting P (pyrolysis
programme) on the clock display.
to reduce power
45