Before You Begin; Combination Installations; Parts Included; Tools And Parts Needed - Thermador ME301YP Guide D'installation

Before you begin

Before you begin
Read these instructions before you begin to install your
Before you begin
appliance.

Combination installations

For combination installations with other Thermador prod-
ucts (i.e. cooktop over oven, side-by-side ovens, etc.),
refer to the Approved Combination Guide located in the
manual set or on our website for additional clearance re-
quirements for your specific installation.

Parts included

After unpacking all the parts, check for any damage in
transit and for completeness of delivery.

Tools and parts needed

Prepare these tools and accessories before you start to
install your appliance.
Pencil
¡
Measuring tape
¡
Level
¡
T-20 star bit screwdriver
¡
Cross head screwdriver
¡
Drill with bit 1/8"
¡
Knife
¡
Gloves
¡

Power requirements and grounding

The outlet must be properly grounded in accordance
with all applicable codes.

Package removal

Package removal
Protect any finished flooring before you move the oven.
Package removal
Removing the packaging from built-in
single and double ovens
Cut the box straps.
1.
Open the top of the carton and remove the top wood
2.
frame.
Remove the carton by lifting it up and off the unit.
3.
Alternatively you can carefully cut along the cut line
on the back left side of the carton with a blade
shorter than 3/4" (20 mm).
Place the unit in front of the cabinet where it is to be
4.
installed. The unit should be in line with the cabinet
cutout.
Leave the unit on the packaging base until it is ready
to be lifted into the cabinet cutout.
Remove all internal protective packaging, racks, ac-
5.
cessories, and instruction manuals from the oven cav-
ity.
8 x Oven mounting screws
(located in the red poly bag in the
broil pan package)
Refer to enclosed leaflet SCREW
INSTALLATION
Remove the packaging brackets.
6.
With a T-20 star bit screwdriver, remove the screws
‒
that go through the slotted holes in the mounting
brackets on the left and right side.
Do not remove any additional screws from the
‒
oven.
a The oven is released from the packaging base.
The brackets remain in the packaging base.
a
Leave the appliance on the packaging base until you
7.
lift it into the cabinet cutout or onto the lower oven.

Installation requirements

Installation requirements
Read these instructions to prepare the installation space
Installation requirements
for your appliance.

Appliance weight

The cabinet base must support the weight of your oven
as stated in this table.
Oven type
30" Single oven
30" Double oven

Location requirements

Ensure your installation location fulfills the following re-
quirements before you begin with the installation proce-
dure.
When an oven is installed at the end of a cabinet run,
¡
adjacent to a perpendicular wall or a cabinet door, al-
low at least 1/4" (6.4 mm) space between the side of
the oven and the wall or door.
For oven support, install 2x4s extending front to back
¡
flush with the bottom and the sides of the opening.
The supporting base must be well secured to the floor
¡
or cabinet and must be level.
The cabinet opening must be plumb and the base
¡
must be flat and level.
When installing a side hinge oven, leave at least
¡
10" (254 mm) clearance to allow the door to open.
Junction boxes can be located anywhere within reach
¡
of the oven's power cable.
Before you begin en-us
Weight
232 lbs
(105 kg)
390 lbs
(177 kg)
7