To Add, Reprogram Or Change A Keyless Entry Pin - Craftsman 139.18458DM Manuel Du Propriétaire

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE "LEARN" BUTTON
1. Press and release the "learn" button
on motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, enter a four digit
personal identification number (PIN) of
your choice on the keypad. Then press
and hold the ENTER button.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To change an existing, known PIN
If the existing PIN is known, it may be changed by one person
without using a ladder.
1. Press the four buttons for the present PIN, then press and hold the
# button.
The opener light will blink twice. Release the # button.
2. Press the new 4-digit PIN you have chosen, then press ENTER.
The motor unit lights will blink once when the PIN has been learned.
Test by pressing the new PIN, then press ENTER. The door should
move.
To set a temporary PIN
You may authorize access by visitors or service people with a
temporary 4-digit PIN. After a programmed number of hours or
number of accesses, this temporary PIN expires and will no longer
open the door. It can be used to close the door even after it has
expired. To set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the last
temporary PIN), then press and hold the ✽ button.
The opener light will blink three times. Release the button.
2. Press the temporary 4-digit PIN you have chosen, then press
ENTER. The opener light will blink four times.

To Add, Reprogram or Change a Keyless Entry PIN

USING THE DOOR CONTROL
NOTE: This method requires two people if the Keyless Entry is already
mounted outside the garage.
1. Enter a four digit personal identification
number (PIN) of your choice on the
keypad. Then press and hold ENTER.
2. While holding the ENTER button, press
and hold the LIGHT button on the door
control.
3. Continue holding the ENTER and LIGHT
buttons while you press the push bar on
the door control (all three buttons are
held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
3. To set the number of hours this temporary PIN will work, press
the number of hours (up to 255), then press ✽.
3. To set the number of times this temporary PIN will work, press
the number of times (up to 255), then press #.
The opener light will blink once when the temporary PIN has been
learned.
Test by pressing the four buttons for the temporary PIN, then press
Enter. The door should move. If the temporary PIN was set to a
certain number of openings, remember that the test has used up one
opening. To clear the temporary password, repeat steps 1-3, setting
the number of hours or times to 0 in step 3.
One Button Close: Opener can be closed by pressing only the ENTER
button if the one button close feature has been activated. This feature
has been activated at the factory. To activate or deactivate this
feature press and hold buttons 1 and 9 for 10 seconds. The keypad
will blink twice when the one button close is active. The keypad will
blink four times when one button close is deactivated.
36
OR